Published 19 November 2026 at 02:39
Two people measure the same pin, each with their own loupe, and get different results. The difference is one or two scale lines, and neither of them has made an obvious mistake. The cause is usually parallax: the scale and the object do not lie in exactly the same plane, so the reading changes depending on the angle from which you look. In a workshop or an inspection department, it is a common and troublesome source of error.
What the Peak Lupe 1999 is
The Peak Lupe 1999 is a handheld measuring loupe with 7x magnification and a built-in glass scale. The optics are not conventional but telecentric. This means that a small aperture is placed at the focal point of the lens system, so the magnification does not change noticeably if the distance to the object varies slightly. The lens system has three elements in two groups and is distortion-free. The loupe measures 38 x 74 mm and weighs 73 grams, so it fits in your pocket.
What problems it solves
Because parallax error essentially disappears, you can measure not only the length and width of flat objects, but also three-dimensional shapes such as cylinders and spheres. The scale is graduated in steps of 0.1 mm over 20 mm, and length can be read with an error of less than 0.03 mm. The manufacturer compares the principle to a profile projector, but here it is an instrument you can bring to the part rather than the other way around.
How to use it
Turn the knurled outer tube until the scale appears sharp through the largest aperture, which is 3 mm. Then place the loupe against the object being measured so that the scale rests against it, and read off the length. The working distance is 20 mm and the field of view is 20 mm.
Three areas of use
In the manufacturing industry, the loupe is used to check the diameter of pins, drilled holes and small shafts right at the machine, without the part having to be moved to a measuring room. In electronics, it is suited to measuring contact parts, conductor diameters and distances on circuit boards, where an error of a tenth of a millimeter matters. In maintenance and installation, you can check wear and dimensions of seals, threads and small pipe parts when you need to decide whether a spare part fits before ordering.
Why it pays off
The biggest gain is that the measurement becomes repeatable. When the result does not depend on who is holding the loupe, there is less debate about whether a dimension is within tolerance, and fewer parts go on to unnecessary rechecking. You also avoid waiting for the measuring lab or a profile projector for dimensions that only need a quick and reliable check. The standard scale is included, and scales can be ordered separately as spare parts if they are damaged or if you need a different graduation.
If you already have a loupe that gives different answers depending on who reads it, that is a clear signal to look at telecentric optics. See the specifications for the Peak Lupe 1999 in our shop.