Published 18 November 2026 at 08:14
The troubleshooting has ground to a halt. There is a suspected leak or a damaged bearing somewhere behind a cover, and the straight probe only reaches the edge. That leaves dismantling, and dismantling brings downtime, new gaskets and the risk of something breaking in the process. Many have been in that position, and many have discovered afterwards that the fault was three centimeters from where they could look.
What it is
This is a handheld inspection camera with a 1 meter long flexible probe and a 5.5 mm camera head. The head is steerable and can be angled up to 270 degrees, so you can look sideways or backwards and not just straight ahead. The camera is built to IP67 and is therefore waterproof. The image is shown on a detachable 3.5-inch TFT screen with a built-in rechargeable battery. The brightness of the LED lighting at the lens is adjustable, and the image can be magnified with 3x zoom.
What problems it solves
The biggest gain is access. With a steerable head you can follow a duct, go around a bend or look at the back of a part that sits tight against a wall. It can also record. Video is stored on microSD cards up to 32 GB, which lets you document a finding, show it to a colleague or attach it to a deviation report. The camera is supplied with a hook, a mirror and a magnet. The hook helps pull out cables, the magnet can retrieve a dropped screw or washer, and the mirror provides an additional viewing angle.
How it is used in practice
Machine shops. Inspection of drilled channels, hydraulic blocks and cast cavities after machining. Chips and burrs sitting behind a crossing hole are rarely visible with straight optics, but can be found when the head can be angled.
Maintenance and installation. Inspection behind enclosures, in ventilation ducts and in tight spaces in electrical distribution or machine housings. You can see whether a cable is chafing or whether there is corrosion, without removing more panels than necessary. Because the camera is waterproof, it can also be used where there is condensation or standing liquid.
Pipes and plumbing. Inspection of pipe bends, connections and spaces behind cabinets and access hatches. One meter reaches far enough for most installations in buildings, and the small diameter gets in where a larger camera cannot.
Why it pays off
Consider the cost of a single unnecessary dismantling. The labor time, the production stoppage and the used-up gaskets quickly cost more than an inspection instrument in this class. If the camera also shows that the fault is somewhere else, you save a second stoppage. The recorded footage also reduces discussions about what was actually seen, since the documentation remains available. For a maintenance team or a quality department, it is a tool that is used often and that replaces several hours of work every time it comes out.
Next steps
If you often reach the limit of what can be seen without taking things apart, you should take a closer look at a camera with a steerable head. Specifications and accessories are available on the product page.