Published 22 November 2026 at 14:40
Many people have stood at a video microscope with a part that is 30 mm in diameter and has a tolerance of ±5 µm. You zoom out until the whole part is visible, click on the edges and get a value that looks exact but isn’t. The problem is not the software but the pixels: when 30 mm is spread across a sensor with 1600 pixels, each pixel corresponds to roughly 17 to 19 µm. At that scale, it is impossible to verify a tolerance of 5 µm.
What the Kitos 30 is
The KITOZOOM Kitos 30 is a video measuring microscope with a 1600 x 1200 pixel USB camera, magnification from 15x to 215x and a working distance of about 170 mm. The illumination is an adjustable LED. Unlike a simpler stand-based solution, the Kitos 30 is built around a 50 x 50 mm XY cross table with two Mitutoyo Digimatic digital indicators. The X and Y coordinates are sent to the KITEC MAX measurement software via the Bobe S-BOX 25 MUX/USB interface.
What problem it solves
The principle is simple. Instead of trying to fit the whole part in the image at low magnification, you use a high magnification where each pixel is small. You then bring one edge at a time to the measuring point by moving the cross table. The coordinates from the digital indicators are combined with the position in the image, and the software calculates the dimension. The resolution is then determined by the magnification and the indicators, not by the size of the part. The system can also be supplied without the interface and data cables, and with KITEC ECO or PRO instead of MAX. The cross table is also available in a 12 mm version instead of 50 mm.
Use in practice
Machine shops. A turned part with a 30 mm diameter and a tight tolerance can be checked without sending it to the metrology room. The same applies to hole spacing and chamfers on small milled parts.
Electronics. The long working distance leaves room for tools under the microscope. This suits inspection of solder joints, spacing between contact surfaces and rework of circuit boards, where images can be saved as documentation.
Plumbing and process engineering. Sealing surfaces, valve seats and worn nozzles can be measured and photographed before and after operation. This provides a basis for replacement decisions, instead of a judgment by eye.
Why it pays off
The value lies in performing the measurement where the manufacturing takes place. Every part that avoids external measurement or an extra trip to the metrology room saves time, and a deviation caught at the machine costs less than one discovered by the customer. The measurement image with coordinates can also be saved as documentation for complaints and quality audits. A system with a clearly defined measurement uncertainty is also worth more than one that gives quick but unreliable numbers.
If you inspect small parts with tight tolerances, you can read more about the configuration and the software options on the product page.